	Ignition Parts

Distributor Cap And Rotor Kit Tan

Zoom

Distributor Cap And Rotor Kit Tan

(2 customer reviews)

SKU:

118483

Availability: Out of stock

Distributor Cap Rotor

List Price:
You Save:

Out of stock

Product Details

Product Length:	9.0 inches
Product Width:	6.0 inches
Product Height:	6.0 inches
Product Weight:	1.0 pounds
Package Length:	7.7 inches
Package Width:	5.4 inches
Package Height:	4.2 inches
Package Weight:	1.55 pounds
Average Customer Rating:	based on 2 reviews

Features

With Brass InsertsHeavy Duty Cap and Rotor Kit
Installation Method - Replacement

Customer Reviews

Average Customer Review: 1.5

( 2 customer reviews )
Write an online review and share your thoughts with other customers.

Most Helpful Customer Reviews

Not the sellers fault Dec 06, 2011 By gatorfan
In spite of reading a negative review of this same product from a different supplier at Amazon, I ordered one of these to replace one like it that was 20 years old on my old car.

Yes there is plastic molding flash and quite a bit of it, that needs to be trimmed off in order to get this to properly seat on the distributor body. The molding flash is due to the injection mold wear at the manufacturer. This is not the distributor/dealer's fault, it is either the molder or the Accel company who actually owns the mold, who does not want to build a new mold or invest in a major mold rebuild for a low volume product. Such is the economy in the US.

Once trimmed, the cap works properly and the price was right. No complaints.

Whoever you buy one of these Accel caps from I suspect the product quality will be the same. This one was manufactured in Canada, not China. The workmanship of the mold is not as good as the old part made 20 years ago, it obviously came from a different mold. I have been involved in injection and compression molding since 1970.

Unfortunately, MSD does not make a screw down cap for the HEI distributor. The only other high performance one that I could find was a Taylor, but the price was higher, maybe the quality is too. You get what you pay for?

Poor fit and finish Dec 01, 2010 By Jerry
The cap was hard to install due to plastic scrap at the base of the cap. The conductor was broken so I had to use the old one. I would not recomend this cap to anyone! Buy Delco or MSD.