A Must-Use For High Performance ConditionsPrevents Tearing Of Original Soft Mount Material
Position:LeftPosition:Right
Customer Reviews
Average Customer Review: ( 1 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
They DO NOT FIT stock mounts! violet shaking worse than solids! Oct 20, 2011
By Kurtis M. Kuszek I purchased these as a cheaper quicker easier temporary repair for torn mounts on a 2001 Honda civic 1.7 mt, an application specifically calling this part # per Energy Suspension's website. I have had good luck with poly filled mounts on a Honda prelude so I thought this would work well. When I went to install them the front mount fit fairly well, but I realized they CLEARLY were cast from a completely different rear mount. The rear insert required massive trimming to even partially fit - even still it was not close and I am not happy with how poorly it fit. I had to cut and bore out 4 or 5 different places as the mount is most definitely NOT the same, only somewhat similar shape.
After install I thought the car would shake violently to the point of vibrating things off the dash, and my dash trim would wobble as much as 1/8 of an in at idle. It was very audible from outside the car and a distance how much the car shook, and this car runs very well. I also own a pretty much race prepped Nissan 240sx with solid block polyurethane replacement motor mounts, and it vibrated FAR less than this!! The rwd 240sx has 2 total mounts, while the fwd honda civic has 4 mounts of which 2 were stiffened and not replaced. A fwd insert should be minimal in it's uncomfort. I can not even see out my rear view mirror.
I have contacted E.S. detailing my notes but do not believe they even gave it notice. I wonder how many bad reviews it takes?
based on 1 reviews
